Water-polymer interfacial area in Nafion: Comparison with structural models

TitleWater-polymer interfacial area in Nafion: Comparison with structural models
Publication TypeJournal Article
Year of Publication2011
AuthorsKong XQ, Schmidt-Rohr K
Journal TitlePolymer
Volume52
Pages1971-1974
Date Published04/19
ISBN Number0032-3861
Accession NumberISI:000289744400014
Keywordsangle, hydration, ionomers, MEMBRANES, nafion, scattering, state, TRANSPORT, water-channel model
Abstract

The water polymer interfacial area per volume, S/V, which is reflected in the Porod region of small-angle scattering data, is an important parameter of different models of the Nation fuel cell membrane. Therefore, we have compared published experimental S/V data of Nafion over a wide range of hydration levels with various structural models featuring stiff polymer backbones, in particular the parallel water-channel and the polymer ribbon models. The S/V curve at intermediate hydration levels typical of fuel-cell conditions (ca. 20 vol% water) matches that of the parallel water-channel model with molecular corrugation. At higher hydration levels, i.e. for membranes soaked in water or autoclaved at elevated pressures, the polymer-ribbon model matches the decreasing S/V ratio with increasing water content, while the polymer-bundle model predicts a higher surface area. However, the ribbon or bundle models cannot apply at low hydration (<3 water molecules per Nafion side group), since we show that the interfacial area in this regime must increase strongly with hydration, being determined by the available surface area of the water molecules. The pronounced asymmetry of the plot of S/V vs. water volume fraction is explained in terms of the difference in the diameters of the water molecules and the polymer aggregates. (C) 2011 Elsevier Ltd. All rights reserved.

URL<Go to ISI>://000289744400014
DOI10.1016/j.polymer.2011.01.020
Alternate JournalPolymerPolymer